You can click in the information bar to allow the add-on or Active-X control to be run.ģ If you are logging in for the first time you may be prompted to download and install the Citrix XenDesktop client software to enable your remote session as shown below. To start using the VLab facilities, open a web browser and navigate to You should see a page similar that shown below where you can login with your Georgia Tech AD account username and password.Ģ Note to Internet Explorer Users: The first time you try to log onto the system you may receive instructions similar to that shown below prompting you to enable the add-on Citrix ICA Client Object to be run. Questions or concerns about the system should be addressed to Didier Contis through Getting Started: Note: If you have previously used the VLab services and installed the Citrix Desktop Receiver we recommend that you remove this software from your system through your control panel as shown below and follow the procedures listed in the remaining part of this document to install the new client. It is similar to having remote desktop access to a Georgia Tech lab computer. 1 Overview: Introduction to the Georgia Tech VLab Project Georgia Institute of Technology, Spring The VLab project (short for Virtual Lab) provides Georgia Tech students, faculty and staff with AD accounts a way to access 'virtual machines' on campus and use software such as MATLAB, AutoCAD, ABAQUS, and Visual Studio from any computer with Internet access.